Optional Tow Hook Release - Horizon Hobby HANGAR 9 Timber 110 30-50cc Manuel D'utilisation

10. Slide the stabilizer into position on the fuselage. Guide the leads into
the fuselage.
11. Secure the stabilizer to the fuselage using two M3 x 10 socket head
cap screw.
 Refer to checking the blind nuts on Page 5
before installing the screws.
 Place a drop of canopy glue on the screws before installation.
This will keep the screws from vibrating loose yet leave
them easily removable to disassemble the model.
 Thumb screws have also been provided to attach
the stabilizer, making it easier to assemble and
disassemble your model without tools.
 Remember to turn the radio system off.
Timber 110 30–50cc ARF

OPTIONAL TOW HOOK RELEASE

 An optional Aerotow Release (HAN526013) can be installed in
this model. It will also require the use of a high-torque servo.
1. Mount the servo in the fuselage with the servo output facing the
bottom of the fuselage.
2. Remove the covering from the fuselage for the aerotow release
using a hobby knife and #11 blade. Mount the aerotow release in the
top of the fuselage. Make sure the slot in the release is parallel to
the trailing edge of the wing. Use a drop of threadlock on the nut to
prevent it from vibrating loose.
 There are two areas on the top of the fuselage that
are covered. The forward location is for lighting, and
the rear location for the aerotow release.
3. Center the aerotow release servo and place the servo arm on the
servo perpendicular to the servo center line. Mark the arm that is
directly below the aerotow release.
4. Thread a clevis on a 12-inch (300mm) pushrod (not included).
Remove any arms on the servo arm that will not be used using side
cutters. Attach the clevis to the servo arm.
5. Slide the pushrod through the aerotow release. Place the servo arm
back on the servo. Use the radio to move the servo to the locked
position.
17 EN