Receiver Installation - Horizon Hobby HANGAR 9 Timber 110 30-50cc Manuel D'utilisation

6. Mark the pushrod at the edge of the release using a felt-tipped pen.
7. Remove the servo arm and pushrod from the fuselage. Cut the
pushrod at the mark. Use a fl at fi le to make a slight point on the end
of the pushrod so it will self-guide through the release.
8. Reinstall the servo arm and pushrod. Check the operation of the
release. Adjust the radio system if the servo binds at full release.
When in the release position, the end of the pushrod must be
completely clear of the slot in the body of the release.
 Remember to turn the radio system off.
EN

RECEIVER INSTALLATION

1. Install the receiver in the fuselage. Mount any remote receivers in
the fuselage using hook and loop tape.
 Apply a small amount of 5-minute epoxy to the hook
and loop tape to secure it to the radio tray.
2. Connect the leads for the elevators and rudder, as well as the 18-
inch (460mm) extensions for the ailerons and fl aps to the receiver.
Route the leads for the ailerons and fl aps to the opening at the top of
the fuselage.
3. Follow the instructions included with the receiver for the correct
locations for the remote receivers.
 The locations shown are possible locations. Ensure
the locations of the remote receivers will not interfere
with components installed later in the build.
18