Rudder Servo Installation - Horizon Hobby HANGAR 9 Carbon Cub FX-3 Manuel D'utilisation

72. Tape the string in the rudder to the lead for the position light.
 Make sure the string is securely attached to
the lead as it will take a fair amount of force
to pull the lead through the rudder.
73. Use the string to pull the wire through the rudder.
74. Use a small amount of epoxy of contact adhesive to glue the
position light in the rudder.
 Use care when transporting your model as
not to damage the position light.
75. Guide the lead for the position light into the fuselage. Route
the lead through the same tube as the elevator servo leads.
 Remove one elevator servo and cover from the fuselage
to access the tube to install the position light lead.
 There are two holes at the bottom of the fuselage.
The lower hole is for the hinge, and one slightly
above it is for the position light lead.
76. Glue the hinges securing the rudder to the fi n.
EN

RUDDER SERVO INSTALLATION

77. Thread a ball end eight turns on each of the four cable
fi ttings.
78. Attach a ball link to the rudder control horn using two M3 x
15 socket head cap screws, two M3 washers and an M3 lock
nut. Install ball ends on both sides of the control horn.
 Do not over-tighten the hardware and
damage the control horn or ball end.
79. Secure the rudder servo in the fuselage with the output of the
servo facing the front of the fuselage. Make sure to prepare
the servo mounting screws holes before installing the servo.
 The elevator and position light leads have been
routed under the radio tray so they do not interfere
with the operation of the rudder cables.
80. Attach two of the ball ends to the rudder servo arm using
two M3 x 15 socket head cap screws, two M3 lock nuts and
two M3 washers. Tighten the hardware using a 2.5mm hex
wrench and 5.5mm nut driver.
81. Slide a sleeve on one of the cables.
14