Aileron Servo Installation - Horizon Hobby Pitts S-2B 50–60cc Manuel D'utilisation

6. Apply epoxy in each of the hinge pockets in the aileron.
7. Fit the hinges into the aileron. Check the alignment of each
hinge.
8. Remove any excess epoxy using a paper towel and isopropyl
alcohol. Check the hinge positions to make sure they were
not disturbed when removing the excess epoxy. Allow the
epoxy to fully cure before proceeding.
9. Mix 1/4 ounce (7.5cc) of 30-minute epoxy. Apply epoxy to the
end of each hinge that will be placed into the wing.
10. Apply epoxy in each of the hinge pockets in the wing.
EN
11. Fit the aileron to the wing. Use a paper towel and isopropyl
alcohol to remove any excess epoxy.
12. Use low-tack tape to hold the aileron in position until the
epoxy fully cures. Allow the epoxy to cure before proceeding.
 The remaining aileron hinges can be glued at this time.

AILERON SERVO INSTALLATION

13. Use a fi nger to locate the position for the aileron control horns
on the underside of the aileron. Use a hobby knife to remove
the covering to expose the control horn mounting location on
the underside of the aileron.
14. Use a fi nger to locate the position for the aileron control horns
on the upper side of the aileron. Use a hobby knife to remove
the covering to expose the control horn mounting location on
the upper side of the aileron..
15. Fit the control horn into position on the underside of the
aileron.
6