Cleaning / Sanitizing Procedure; Cleaning Procedure - Manitowoc Indigo Série Manuel D'installation, D'utilisation Et D'entretien

Masquer les pouces Voir aussi pour Indigo Série:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance

Cleaning / Sanitizing Procedure

! Caution
Use only Manitowoc approved Ice Machine Cleaner
and Sanitizer for this application (Manitowoc
Cleaner part number 94-0546-3 and Manitowoc
Sanitizer part number 94-0565-3). It is a violation of
Federal law to use these solutions in a manner
inconsistent
with
understand all labels printed on bottles before use.

CLEANING PROCEDURE

! Caution
Do not mix Cleaner and Sanitizer solutions together.
It is a violation of Federal law to use these solutions
in a manner inconsistent with their labeling.
!
Wear rubber gloves and safety goggles (and/or face
shield) when handling Ice Machine Cleaner or
Sanitizer.
Ice machine cleaner is used to remove lime scale and
mineral deposits. Ice machine sanitizer disinfects and
removes algae and slime.
NOTE: Although not required and dependent on your
installation, removing the ice machine top cover may
allow easier access.
Step 1 Open the front door to access the evaporator
compartment. Ice must not be on the evaporator during
the clean/sanitize cycle. Follow one of the methods
below:
Press the power switch at the end of a harvest cycle
after ice falls from the evaporator(s).
Press the power switch and allow the ice to melt.
! Caution
Never use anything to force ice from the evaporator.
Damage may result.
Step 2 Remove all ice from the bin/dispenser.
38
their
labeling.
Read
Warning
Step 3 Press the clean button. Water will flow through
the water dump valve and down the drain. Wait until the
water trough refills and the display indicates add
chemical (approximately 1 minute), then add the proper
amount of ice machine cleaner.
Model
and
I0300/I0320/I0520
I0450/I0500/I0600/I0850
I0900/I1000/I1100/I1200
I1400/I1800
Step 4 Wait until the clean cycle is complete
(approximately *24 minutes). Then disconnect power to
the ice machine (and dispenser when used).
Disconnect the electric power to the ice machine at
the electric service switch box.
Step 5 Remove parts for cleaning.
Please refer to the proper parts removal for your ice
machine. Continue with step 6 when the parts have
been removed.
Single Evaporator Ice Machines - Page 40
Section 4
Amount of Cleaner
3 ounces (90 ml)
5 ounces (150 ml)
9 ounces (265 ml)
!
Warning
Part Number 000007345 2/14

Publicité

Chapitres

Table des Matières
loading

Table des Matières