Ice Machine Heat Of Rejection; Removing Drain Plug And Leveling The Ice Storage Bin; Air Baffle - Manitowoc Indigo Série Manuel D'installation, D'utilisation Et D'entretien

Installation Instructions

Ice Machine Heat of Rejection

Series
Ice Machine
Air Conditioning
I0300
I0320
I0450
I0500
I0520
I0600
I0850
I0906
I1000
I1100
I1200
I1400
I1800
B.T.U./Hour
Because the heat of rejection varies during the ice making cycle,
the figure shown is an average.
* Indicates Preliminary Data
Ice machines, like other refrigeration equipment, reject
heat through the condenser. It is helpful to know the
amount of heat rejected by the ice machine when sizing
air conditioning equipment where self-contained air-
cooled ice machines are installed.
This information is also necessary when evaluating the
benefits of using water-cooled or remote condensers to
reduce air conditioning loads. The amount of heat added
to an air conditioned environment by an ice machine
using a water-cooled or remote condenser is negligible.
Knowing the amount of heat rejected is also important
when sizing a cooling tower for a water-cooled
condenser. Use the peak figure for sizing the cooling
tower.
10
Heat of Rejection
Peak
4600 5450
3300 4500
5400 6300
6100 6900
5400 6300
9000 13900
13000 16000
13000 16000
16250 18600
16250 18600
20700 24500
23500 27000
30000 35000
Removing Drain Plug and Leveling the Ice
Storage Bin
!
To avoid instability the bin/dispenser must be
installed in an area capable of supporting the weight
of the bin/dispenser, ice machine and a full bin of ice
(48" models 1000 lbs - 454 kg, 30" models 750 lbs
340 kgs). The bin/dispenser must be level side to
side and front to back before installing the ice
machine.
1. Remove threaded plug from drain fitting.
2. Screw the leveling legs onto the bottom of the bin.
3. Screw the foot of each leg in as far as possible.
! Caution
The legs must be screwed in tightly to prevent them
from bending.
4. Move the bin into its final position.
5. Level the bin to assure that the bin door closes and
seals properly. Use a level on top of the bin. Turn the
base of each foot as necessary to level the bin.
6. Inspect bin gasket prior to ice machine installation.
(Manitowoc bins come with a closed cell foam
gasket installed along the top surface of the bin.)
7. Remove all panels from ice machine before lifting.
and installing on bin. Remove both front panels, top
cover, left and right side panels.

Air Baffle

Self-Contained Air-cooled Only
The air-cooled baffle prevents condenser air from
recirculating. To install:
1. Loosen the back panel screws next to the
condenser.
2. Align the keyhole slots in the air baffle with the screw
holes and slide the baffle down to lock in place.
Section 2
Warning
AIR
BAFFLE
Part Number 000007345 2/14