Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Section 3
AIR FILTER
The ice machine has a feature that displays a clean air
filter reminder at a set time interval.
1. From the Set-Up menu, use the Down arrow to
highlight Air Filter.
2. Press the Checkmark. On this screen, you can
choose to turn the reminder to AUTO or OFF by
highlighting your choice and pressing the
Checkmark. Selecting one will deselect the other.
3. You can also choose the time interval from this
screen by highlighting Set Interval and pressing the
Checkmark.
4. Press the Left arrow to return to previous screens
and to the Set-Up menu.
WATER FILTER
The ice machine has a feature that displays a replace
water filter reminder at a set time interval.
1. From the Set-Up menu, use the Down arrow to
highlight Water Filter.
2. Press the Checkmark. You can record the filter type
on this screen by highlighting Filter Type and
pressing the Checkmark.
3. After making your selection, press the Left arrow to
return to the previous screen.
4. On this screen, you can also choose to turn the
reminder to AUTO or OFF by highlighting your
choice and pressing the Checkmark. Selecting one
will deselect the other.
5. You can further choose the time interval from this
screen by highlighting Set Interval and pressing the
Checkmark.
6. Press the Left arrow to return to previous screens
and to the Set-Up menu.
Part Number 000007345 2/14
LUMINICE™ REMINDER
The LuminIce™ growth inhibitor recirculates the air in
the ice machine foodzone over a UV bulb. This process
will inhibit the growth of common micro-organisms on all
exposed foodzone surfaces.
The LuminIce™ is a feature that displays a reminder to
change its bulb every 12 months.
1. From the Set-Up menu, use the Down arrow to
highlight LuminIce™.
2. Press the Checkmark. On this screen, you can
choose to turn the reminder to AUTO or OFF by
highlighting your choice and pressing the
Checkmark. Selecting one will deselect the other.
3. When the check reflects your preference, use the
Down arrow to navigate to Exit and press the
Checkmark. The display will return to the Set-Up
menu.
ICE BIN LEVEL SENSOR
Ice bin sensor is an optional accessory that allows the
ice level in the bin to be set to one of three different
levels. The bin level can be set seasonally to match
usage, which results in lower energy costs and fresher
ice.
1. From the set-up menu, use the Down arrow to
highlight Ice Bin Sensor.
2. Press the Checkmark. On this screen you can
choose to set the ice level to low, medium or high by
highlighting your choice and pressing the
Checkmark. Selecting one will deselect the other.
When the check reflects your preference, use the Down
to navigate to Exit and press the Checkmark. The
display will return to the Set-up menu.
USB SETUP
Refer to "Upgrading Firmware with a Flash Drive" and
"Exporting Data to a Flash Drive" for more information on
this setting.
FACTORY DEFAULTS
The entire setup can be reset to factory defaults listed on
page 28.
1. From the Set-Up menu, use the Down arrow to
highlight Fact Default.
2. Press the Checkmark two times to reset the ice
machine. The display will return to the Set-Up menu.
Operation
31
Publicité
Chapitres
Table des Matières
