Start-Up And Run-Down Parameters; Start-Up Stage And Start-Up Time; Braking Stage And Run-Down Time; Brake Switch-Off Speed - Hettich ROTANTA 460 Mode D'emploi

18.5

Start-up and run-down parameters

The set start-up and run-down parameters are displayed.
x: 1-9 = start-up stage, t = start-up time
y
y: 1-9, 1b-9b = braking stage, 0 = unbraked run-down, t = run-down time
x
18.5.1

Start-up stage and start-up time

It is only possible to set start-up times if these have been activated. See the chapter "Activating or deactivating
start-up and run-down times".

Press the key. The parameter
= start-up stage, t = start-up time
Press the key to switch between the start-up stage and start-up time.
TIME

Set the desired stage or time with the rotary knob .

If necessary, press the

To apply the setting to the display, either press the
the centrifugation data are displayed.
18.5.2

Braking stage and run-down time

B-brake stages can only be set for rotors which are suitable for the use of blood bags.
The B-braking stages can only be set if this is activated. See chapter "Activate or deactivate B-braking
stages".
It is only possible to set run-down times if these have been activated. See the chapter "Activating or
deactivating start-up and run-down times".

Press the key until the parameter
= braking stage, = B- braking stage,
Press the key to switch between the braking stage and run-down time.
TIME
The B-braking stages are displayed after braking stage 9.

Set the desired stage or time with the rotary knob .
The B-braking stages are displayed after braking stage 9.

If necessary, press the

To apply the setting to the display, either press the
the centrifugation data are displayed.
18.5.3

Brake switch-off speed


Press the key as often as necessary until the parameter N Brake is shown.

Use the adjusting knob

Press the or
START
AB5650DEENFRIT
or t is displayed.
key to set the next parameter.
START
or or t
t = run-down time
key to set the next parameter.
START
to set the value you want.
keys to apply the setting to the display.
Rev. 16 / 04.2020
key or press the key as often as is required until
is displayed.
key or press the key as often as is required until
EN
73/220