Setting Program Locks - Hettich ROTANTA 460 Mode D'emploi

EN
32

Setting program locks

When the rotor is at a standstill, the following program locks can be set:
LOCK 1 LOCK 1 is displayed in the "
Programs can only be called up but not modified.
LOCK 2 LOCK 2 is displayed in the "
No programs can be called up and modified.
The centrifuge can be controlled via the interface (only for centrifuge with interface).
LOCK 3
No status display.
No program locking. Programs can be called up and modified.
The operation can be cancelled at any time by pressing the
stored.

Keep the key held down for 8 seconds.
PROG
After 8 seconds,  Machine Menu  appears in the display.

Press the key as often as necessary until the ->Change LOCK is displayed.
PROG

Press the key.The lock status is displayed.
START
If no PIN has been entered, LOCK = 3 confirm by START, for example, will be displayed.
If a PIN has been entered, LOCK = 3, for example, will be displayed.

Use the adjusting knob to set the desired lock status.
If a PIN has been entered, PIN = ---- confirm by START will be shown. In this case, a valid PIN has to
be entered with the
status can be set.

Press the key to save the setting.
START
Briefly, Store LOCK 2 ... is displayed as confirmation, followed by -> Change LOCK.

Press the key once to exit the "Change LOCK" menu or press the
OPEN / STOP
"Machine Menu".
84/220
" field.
" field.
adjusting knob and then the
Rev. 16 / 04.2020
key. In this case, the settings are not
OPEN / STOP
button has to be pressed before the lock
START
OPEN / STOP
key twice to exit the
AB5650DEENFRIT