Tunturi Pure 8.1 Rower Mode D'emploi page 9

• Finish the rear leg assembly by
installing the second rear leg bolt (13)
and washer (5).
• Tighten both front and rear bolts.
Be careful tightening bolts to prevent
scratches
ASSEMBLY STEP 6
• Finish the rear leg assembly by
installing the second rear leg bolt (13)
and washer (5).
• Tighten both front and rear bolts.
Be careful tightening bolts to prevent
scratches
ASSEMBLY STEP 7
O w n e r ' s m a n u a l
For the next assembly step, you will
need:
• seat rail assembly (previously
assembled)
• main frame (1)
• 2x horizontal seat rail bolts
(M10x120mm) (4)
• 2x washer (5)
• 2x nylock nuts (6)
ASSEMBLY STEP 8
Insert the seat rail until it just slightly
protrudes behind the footplate. Shown
above is the installation / alignment point
for the M10x120mm horizontal seat rail
bolt (4), M10 washer (5) and nylock nut
(6)
ASSEMBLY STEP 9
Install and secure the two bolts (4) and
two washers (5) with the nylock nuts (6).
•
P U R E R O W 8 . 1
GB
9