Warranty; Declaration Of The Manufacturer; Disclaimer - Tunturi Pure 8.1 Rower Mode D'emploi

Front of rower lifts slightly during
vigorous rowing.
Possible cause:
Vertical seat rail tensioning bolt
(M10x150mm) is too loose.
Solution:
• Tighten bolt 1/2 turn and row again.
Tighten as needed until problem
stops.
Over tightening this bolt can damage
the seat rail. Only tighten bolt in small
increments until fault is corrected.
The rowing console does not
illuminate after battery installation.
Possible cause:
Batteries installed incorrectly or need
replacing.
Solution:
• Reinstall batteries in correct position
and try again.
• If the LCD screen fails to illuminate,
try rotating the batteries slightly in the
console.
• If this fails, contact your local service
centre.
The rowing console screen
illuminates, but does not register
when rowing.
Possible cause:
Loose or failed connection
Solution:
• Check that the console lead is
connected properly.
• If it is connected then contact your
local service centre.
O w n e r ' s m a n u a l

Warranty

The product has a warranty from the
date of delivery (to be documented
by invoice or delivery note). Further
information on warranty terms can be
obtained from your local dealer. The
warranty terms may vary from one
country to another. Damages caused by
normal wear, overloading or improper
handling are excluded from the warranty.
Damages caused by material or
manufacturing faults are covered by the
warranty and will repaired or replaced at
no cost.
Declaration of the
manufacturer
Tunturi New Fitness BV declares that the
product is in conformity with the following
standards and directives: EN 957 (SC),
89/ 336/ EEC. The product therefore
carries the CE label.
09-2014
Tunturi New Fitness BV
P.O. Box 60001
1320 AA Almere
The Netherlands

Disclaimer

© 2014 Tunturi New Fitness BV
All rights reserved.
The product and the manual are subject
to change.
Specifications can be changed without
further notice.
•
P u r e r O W 8 . 1
GB
17