Troubleshooting - Tunturi Pure 8.1 Rower Mode D'emploi

• Wind the rower belt onto the belt /
bungee pulley until the rower handle
is at its furthest forward position.
• 6. Re thread the bungee cord
(on opposite side of the idle wheel)
back through the bungee pulleys and
tie off at the attachment point.
BUNGEE CORD ROUTE (RED LINE)
16
NOTE
• If bungee cord previous tension
seemed correct (a good way to judge
is if the rower handle can make it
to the furthest point forward on the
top of the mainframe under bungee
tension alone) then simply tie off at
previous position.
• If the return is too slack, experiment
by tightening the tension in small
increments and testing until the
correct tension is achieved.
• If the rower handle cannot reach the
end of the seat rail during a rowing
stroke, then the bungee cord is over-
tensioned.

Troubleshooting

Water changes color or becomes
cloudy
Possible cause:
Rower is in direct sunlight or has not had
water treatment.
Solution:
• Change rower location to reduce
direct exposure to sunlight.
• Add water treatment or change
tank water as directed in the water
treatment section of this manual.
Rower belt slipping off belt / bungee
pulley
Possible cause:
Bungee cord not under enough tension.
Solution:
• Tighten bungee cord following the
instructions in "Re-attaching the
rowing belt" - step 8 of this manual.