General Assembly Information; Assembly Steps - Tunturi Pure 8.1 Rower Mode D'emploi

17 Hex key (6mm)
18 Owners manual
19 Siphon
20 Water treatment tablets (x4)
21 Vertical seat rail bolt dampener
22 Internal seat rail bolt bracket
The package contains the parts as
shown in figure.
If a part is missing, contact your dealer.

General assembly information

WARNING
• Assemble the equipment in the given
order.
• Carry and move the equipment with
at least two persons.
CAUTION
• Place the equipment on a firm, level
surface.
• Place the equipment on a protective
base to prevent damage to the floor
surface. surface.
• • Allow at least 100 cm of clearance Allow at least 100 cm of clearance
around the equipment. around the equipment.
Refer to the illustrations for the correct
assembly of the equipment.
O w n e r ' s m a n u a l

Assembly steps

ASSEMBLY STEP 1
• Install the rower seat (3) onto the
seat rail (2) as shown.
NOTE
• The rail rear end has two mounting
holes.
ASSEMBLY STEP 2
For the next assembly step, you will
need:
• ·rear leg (11)
• ·2x rear seat rail bumpstops (9)
• ·2x rear leg bolts (M10x120mm) (13)
• ·2x washer (5)
• ·seat rail bracket (12)
• ·rubber end cap (10)
• ·internal seat rail bracket (22)
•
P U R E R O W 8 . 1
GB
7