Setting The Rowing Resistance - Tunturi Pure 8.1 Rower Mode D'emploi

ASSEMBLY STEP 10
• Install the vertical seat rail bolt (7)
with plastic dome cap (8) through the
seat rail assy.
• Fit the vertical seat rail bolt dampener
(21) onto the bolt end sticking out of
the seat rail assy.
NOTE
The vertical seat rail dampener is
designed to take up the slack between
the seat rail and mainframe when the
rower is stored / standing in a vertical
position.
ASSEMBLY STEP 11
10
• Secure the seat rail bolt with seat rail
bolt dampener into the lower main
frame (1).
Do not tighten the bolt (7).
The vertical seat rail tensioning bolt (7) is
designed to hold the mid leg 3-5mm off
the ground when the rower is standing
on the ground without a person on it.
During operation the mid leg will just
slightly touch the ground during a rowing
stroke.
NOTE
If excessive shaking/hopping of the tank
occurs during rowing, this indicates the
vertical seat rail tensioning bolt (7) is out
of adjustment and should be tightened.
Setting the rowing
resistance
(ADJUSTABLE WATER LEVEL)
The patented adjustable water level
offers a true multi-level experience.Water
is moved between the "storage" and
"active" chambers of the tank. Your new
Tunturi Rower can adapt - at the turn
of a dial - to the resistance preferred by
each user.
MAX:
This setting allows the maximum amount
of water to reach the rowing Blades
inside the tank for heaviest resistance
MIN:
Keeps a portion of the water in the
inner tank compartment, creating light
resistance.