Tunturi Pure 8.1 Rower Mode D'emploi page 8

ASSEMBLY STEP 3
With the seat already installed on the
rail, thread the rear rubber bumpstops
(9) onto the end of the seat rail (2) as
shown.
ASSEMBLY STEP 4
• Insert the internal seat rail backet
(22) into the rear end of the rail and
align the internal seat rail bracket
hole with the seat rail front bolt hole.
• Insert the bolt (13) with washer (5)
throught the seat rail bracket (12)
into the seat rail front bolt hole and
internal seat rail bracket.
• Secure the bolt into the rear leg (11)
8
NOTE
• The oval end of the seat rail bracket
(12) is facing forward as shown.
• Do not thighten the bolt (13).
ASSEMBLY STEP 5
Install the rubber end cap (10)
ASSEMBLY STEP 6