Table des Matières
Publicité
Setting the width adjustment
Adjustment of the Brush deck must take place with the deck in the raised position.
Lift the Deck locking knob located at the front of the machine. (see fig.14), then pull the side pod at the handle position
to expand or close to contract the deck to the desired width - 650mm (see Fig.15) or 550mm (see Fig.16).
1
Fitting the brushes
2
2x 330mm Brush for 650 mm setting (Fig.15).
2x 280mm Brush for 550 mm setting (Fig.16).
Featuring the new OBS (Octagonal Brush System);
The brushes simply push-fit up onto the chucks making fitting and removal a simple process.
Ensure the Brush deck is set to the appropriate width for the brushes being used.(fig.15, fig.16).
Slide the brush under the brush deck (fig 17).
Fit the brushes onto the OBS drive chuck (fig.18).
Safety gloves are recommended for the changing of used brushes.
Note:
Check the deck width setting is correct with the selected brushes before use.
12
Fig.14
Note: Use 2x 330mm Brush size for
Note: Remove the brushes before adjusting width!
Fig.15
650mm setting.
650mm
Fig.17
244033 05/14 (A11)
Fig.16
Note: Use 2x 280mm Brush size for
550mm setting.
550mm
Fig.18
Publicité
Table des Matières
