Table des Matières
Publicité
!
The floor-tool
To clean the floor-tool, remove securing-pin and pull-free from the holder (see fig.53).
Rinse the floor-tool assembly with clean water and refit.
Periodically the floor-tool blades should be examined and checked for wear and damage.
The blade removal is easy. Simply start by removing the four retaining pins (see fig.54), turn the
floor-tool over and separate the blade carrier from the body (see fig.55).Peel away the blades from their locating lugs
(see fig.56) and examine or renew as required.
Replacement is a reversal of the removal process.
Floor-tool overview (fig.57).
1. Floor-tool main body
2. Rear blade
3. Blade carrier
4. Front blade (slotted)
5. Retaining pins x 4
30
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY
MAINTENANCE USING THE MASTER CONTROL ON/OFF KEY.
REMOVE THE KEY PRIOR TO ANY MAINTENCANCE OPERATION.
Fig.53
Fig.55
1
2
3
4
5
244033 05/14 (A11)
Fig.54
Fig.56
Fig.57
!
Publicité
Table des Matières
