Table des Matières
Publicité
!
Machine in use
Fig.44
24
ALWAYS ENSURE THAT THE FLOOR IS PRE-SWEPT
AND RELEVANT SAFETY SIGNS ARE DISPLAYED.
To operate, turn the master control On / Off key to the 'ON' posi-
tion, select water flow rate, chemical mix (see page 20), lower the
floor-tool (see page 18) and select forward (see page 8, fig.6),
press the start / stop trigger.
Vacuum pick-up, water-flow and chemical-dose will turn on
automatically and the machine will move forward.
Adjust the speed to suit the conditions using the variable speed
control (see page 8).
The clean water / chemical mix is dispersed evenly via
'THRU- FEED' scrubbing brushes.
The waste water is then retrieved by the suction floor-tool
(see page 10).
Overlap each scrubbing path by 10cm to ensure
an even clean (fig.44).
Do not operate the machine on inclines that exceed (9%), when
full.
NOTE: Care must be taken to reduce speed when
cornering or when manoeuvring around obstacles.
If streaking occurs wipe floor-tool blades clean (see fig.45).
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor-tool in the raised position,
allow the chemical time to work then scrub the area a second
time with the floor-tool lowered.
Fig.45
244033 05/14 (A11)
!
Publicité
Table des Matières
