Table des Matières
Publicité
Setting the cleaning controls
Fig.34
Fig.35
Fig.36
Fig.37
Brush pressure / Load adjustment
The brush load lever is located to the right hand side of the machine.
This feature allows you to increase the pressure of the brushes for stubborn stains.
It is recommended this option is NOT used all the time and is for spot cleaning only.
The run-time of the machine may decrease if the load on the brushes is increased.
20
Insert the key into the master control on/off and quarter-turn it clockwise to the 'ON' position
(fig.34).
The battery charge-level indicator will illuminate for 5 seconds.
Set Water Flow Rate as required, depending on floor type and level of soiling (fig.35).
Set automatic Chemical Dosing Mix as required, depending on floor type and level of soiling
(fig.36).
100:1 75:1 50:1 25:1
Set desired traction Speed as required, depending on floor type and
level of soiling.
Middle speed is the optimum cleaning speed.
Once the MAX speed has been set using the knob on the control panel
(fig.37), fine adjustments can be made using the variable speed control
handle (fig.37a).
The TTV-5565 has been fitted with a Hi - Lo mode, this reduces the noise produced by
the vacuum motor by 3dB.
To operate the Hi - Lo mode start the machine in the normal way.
When the machine is running normally the Hi - Lo light will NOT be
illuminated This means the Vacuum motor is running at 100%.
With the machine running press the Hi - Lo button once the Vacuum motor will reduce
speed to 75% of capacity and the Hi - Lo light will illuminate Blue.
The brush load indicator on the control display shows the pressure applied, when the
machine is being operated.
Fig.38
(A) Standard Duty
17 Kg Pressure
(fig.38)
A
0.5 L / Min
1 L / Min
2 L / Min
3 L / Min
100 : 1
75 : 1
50 : 1
25 : 1
Fig.38 a
Fig.38 b
NOTE:
244033 05/14 (A11)
Fig.37a
(B) Heavy Duty
30 Kg Pressure
B
(fig.38a)
(C) Extra Heavy Scrub
50 Kg Pressure
C
(fig.38b)
1
2
Publicité
Table des Matières
