Nikon AF-S DX NIKKOR 18-300mm f/3.5-5.6G ED VR Manuel D'utilisation page 19

Using the Vibration Reduction Mode Switch

The vibration reduction mode switch is used to select the

vibration reduction mode when vibration reduction is on.

Select NORMAL to reduce vibration caused by

camera shake or when panning the camera.

Select ACTIVE to reduce vibration caused by

camera shake or when shooting from a moving

car, boat, or other unstable platform. Panning

motions are not detected.

Using Vibration Reduction: Notes

• When using vibration reduction, press the shutter-release

button halfway and wait for the image in the viewfinder to

stabilize before pressing the shutter-release button the rest

of the way down.

• When vibration reduction is active, the image in the

viewfinder may be blurred after the shutter is released. This

does not indicate a malfunction.

• Slide the vibration reduction mode switch to NORMAL for

panning shots. When the camera is panned, vibration

reduction applies only to motion that is not part of the pan

(if the camera is panned horizontally, for example, vibration

reduction will be applied only to vertical shake), making it

much easier to pan the camera smoothly in a wide arc.

• Do not turn the camera off or remove the lens while

vibration reduction is in effect. If power to the lens is cut

while vibration reduction is on, the lens may rattle when

shaken. This is not a malfunction, and can be corrected by

reattaching the lens and turning the camera on.

• If the camera is equipped with a built-in flash, vibration

reduction will be disabled while the flash charges.

• Turn vibration reduction off when the camera is securely

mounted on a tripod, but leave it on if the tripod head is not

secured or when using a monopod.

Table des Matières

Chapitres

Af-s dx nikkor