Safety And Accident Prevention Regulations; Hazard Levels; Safety Signs - spanesi MINIBENCH MAXIPLUS Manuel D'utilisation Et De Maintenance

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

SECTION 2
SAFETY AND ACCIDENT PREVENTION
REGULATIONS

2. HAZARD LEVELS

Operator and personnel safety is the main concern of
machine designers and manufacturers.
When designing a new machine, the designer tries to take
account of all possible hazards and risks connected with
the use of the machine, taking all suitable precautions to
make the equipment as safe as possible.
The number of accidents nevertheless remains very high
due above all to careless and clumsy operator use.
You are therefore advised to read this manual very carefully
and in particular this section concerning safety precautions,
and make sure that you always use the machine correctly
and follow the instructions in this manual:
WARNING! Read the following instructions
carefully.Anyone who fails to observe them
may suffer permanent injury or permanently
injure other persons or animals or damage
property. SPANESI declines all responsibility
for direct or indirect damages caused by
failure to observe the safety precautions and
accidentprevention directions set out below.
Pay attention to the hazard warning sign when
it appears in this manual and observe all safety
provisions.
There are three types of hazard warning sign:
DANGER!
This sign warns that if the operations described are not
correctly performed, they will cause serious injury or death
or involve long-term health risks.
WARNING!
This sign warns that if the operations described are not
correctly performed, they can cause serious injury or death
or involve long-term health risks.
CAUTION!
This sign warns that if the operations described are not
correctly performed, the machine can be damaged.
WARNING!
SPANESI
responsibility for direct and indirect damage
caused by incorrect use of the MINIBENCH
MAXIPLUS and/or caused by modifi cations
carried
out
authorisation.

2.1 SAFETY SIGNS

The safety signs described in this manual are affi xed to the
lift and indicate unsafe and dangerous situations.
The labels must be kept clean and must be immediately
replaced when they come off or are damaged.
1)
Carefully read and learn the meaning of the safety
signs:
2)
The instruction manual must be carefully read before
beginning work.
3)
Before carrying out any maintenance operation,
the lift must be stopped and disconnected, and the
instruction manual must be consulted.
4)
Danger of shearing: keep a safe distance during
raising and lowering of the lift.
5)
Danger of falling: never climb onto the lift.
58
S.p.A.
declines
without
the
manufacturer's
all

Publicité

Table des Matières
loading

Table des Matières