Lighting The Side Burner; Primezone (Optional Equipment); Using / Starting Up The Primezone In The Main Cooking Area - Rösle Artiso G2 Mode D'emploi

Lighting the side burner

1. Open the side burner lid before lighting the side burner.
2. Before starting the lighting procedure, the control knob must be set to the position "• OFF".
3. Open the valve at the gas cylinder if you have not already done so.
4. Press the control knob 7 inwards and turn it anti-clockwise to the position "MAX". That initiates the ig-
nition spark.
5. If the burner does not light immediately, turn the control knob back to " • OFF", wait 1 minute to allow
the accumulated gas to disperse and then repeat the lighting procedure.
6. In exceptional cases, use a match to light the burner if the igniter does not produce a spark.
7. You can now use the control knob to adjust the flame to suit your particular requirements. For the lo-
west setting, you turn the control anti-clockwise to "MIN".
8. If you do not succeed in lighting the grill, refer to the section headed "Troubleshooting" on page 43.

Primezone (optional equipment)

The Primezone with an infrared gas burner is ideal for flash frying, e.g. steaks, in order to obtain a crispy
texture at approx. 800°C surface temperature .
The gas grill should be positioned so that the Primezone is sheltered from the wind where possible
as strong winds may effect its performance.
Never use the grate of the Primezone as a tray for grilled food. Liquids and grease drop into the ce-
ramics and clog up which may impair the function.
Never bend over the open grill. Always keep at least 30 cm away from the igniter opening when
lighting the Primezone.
The infrared gas burner generates very intensive heat. Do not leave grilled food on the burner unat-
tended as it may burn quickly. Leave the lid of the grill open when using the infrared gas burner at a
high flame. This allows better monitoring of the grilled food in order to avoid burning.

Using / Starting up the Primezone in the main cooking area

1. Open the lid of the grill.
2. Before starting the lighting procedure, the control knob must be set to the position "• OFF".
3. Open the valve at the gas cylinder if you have not already done so.
4. Press the control knob 12 inwards and turn it anti-clockwise to the position "MAX" - that initiates the
ignition spark.
5. If the burner does not light immediately, turn the control knob back to " • OFF", wait 1 minute to allow
the accumulated gas to disperse and then repeat the lighting procedure.
6. In exceptional cases, use a match to light the burner if the igniter does not produce a spark.
7. You can now use the control knob to adjust the flame to suit your particular requirements. For the lo-
west setting, you turn the control anti-clockwise to "MIN".
8. Operate the grill with the lid open for 5 minutes or until the ceramic burner is red.
9. Place meat or other items for barbecuing on the grate over the Primezone and grill according to the re-
cipe.
10. Continue to grill depending on your taste and desired cooking level at high, medium or low tempera-
ture and turn the food often.
11. Alternatively, place the food from the Primezone onto the main grill area, close the lid and slow cook at
120 - 160°C. Switch off the Primezone and turn to " • OFF".
12. If you do not succeed in lighting the Primezone, refer to the section headed "Troubleshooting" on page
43.
35