Gas-Tightness Test; Important Operating Instructions - Rösle Artiso G2 Mode D'emploi

Ensure that the connectors are firmly mounted and gas-tight.
Use suitable hose clips or crimp clamps to fix the hose to the adaptor and tighten the clips/clamps se-
curely. Once you have fitted and checked the hose/pressure regulator connection to the gas grill, turn on
the gas cylinder and check the connections for leaks. Make sure that you keep well away from any possible
sources of ignition during this process.
• Keep the gas hose and the electrical power cord away from hot parts.
• Avoid twisting the gas hose unnecessarily.
• Always check the gas hose for cracks, pinches, wear and other damage before using the grill. If the gas
hose shows signs of damage or wear, it must be replaced immediately.
• Replace the gas hose if damaged or when required by national statutory regulations.

Gas-tightness test

Never use a naked flame to check for leaks at the gas connections. If you smell
gas, turn off the gas cylinder immediately.
Every time before starting up the appliance and whenever the gas cylinder has
been replaced, carry out the "gas-tightness test" according to instructions.
Do not use damaged gas cylinders. Dented or rusty gas cylinders or gas cylinders
with damaged valves are potentially dangerous and should be replaced immedi-
ately with a fully intact cylinder.
1. Firmly connect all gas-conveying components.
2. Turn all control knobs to "• OFF".
3. Open the valve at the gas cylinder.
4. Apply a soap-and-water solution made by mixing water with a proportion of detergent or a leak loca-
tor spray to all gas connections (gas cylinder, gas pressure regulator, gas hose connections).
5. If soap bubbles appear, it means that there is a leak at that point.
IMPORTANT: The grill must not be used until all leaks have been eliminated.
6. In this case close valve at the gas cylinder.
7. Eliminate the leaks by tightening the connections, if possible, or replacing any defective parts.
8. Repeat leak test.
9. If you smell gas and cannot find any leaking joints on the grill, turn off the gas cylinder, detach the hose
and immediately contact your supplier or the shop where you bought the appliance.

Important operating instructions

The ability of the user to correctly assemble and safely use the grill can be impaired by the consumption of
alcohol, drugs and/or prescription or non-prescription drugs. This appliance is not intended to be used by
people (including children) with limited physical, sensory or mental capabilities or without the necessary ex-
perience and/or knowledge unless they are supervised by a person responsible for their safety or are instruc-
ted by such a person on how the appliance is to be used.
• Do not use this grill until all components have been properly assembled and the gas-tightness test has
been carried out. Incorrect assembly can be dangerous. Please pay strict attention to the assembly inst-
ructions.
• Only use this grill in the open in a well ventilated but sheltered place with firm, flat surface.
• The RÖSLE grill is not intended for assembly or use in or on caravans, camper vans, food trucks and/or
boats.
• Do not move the grill over high ledges/steps or very uneven surfaces and only move the grill after it has
cooled down.
• Do not use the grill in garages, buildings, walkways between buildings or any other such enclosed
space. Otherwise poisonous vapours may collect that could cause serious or even fatal injuries.
• Never operate the grill underneath combustible roofs canopies, etc. Whenever using this grill, make
sure it is at least 1.5 m away from any combustible or heat-sensitive materials.
31