Mondolfo Ferro TBE160 TERRA Manuel D'utilisation page 70

WARNING
Make sure that the rim is correctly and firmly locked on every gripping point of the
turntable clamp.
WARNING
Any operation intended to modify the setting value of the relief valves is forbidden.
The manufacturer declines all liability for damage resulting from tampering with
these valves.
The pressure should be reduced for weak or particularly thin rims; for thick rims that
are difficult to demount, it is recommended to adjust pressure to the maximum level.
Adjust the opening of the turntable using the "closing/opening" control (C, Fig. 14)
based on the type of rim to lock (see examples in Fig. 19).
Fig. 19
Fig. 20
If the rim exceeds 44" in the locking
point, insert the extensions available as
accessory (Fig. 20).
Position the wheel vertically on the
machine surface (Fig. 21).
Use the controls to set the turntable so
that the ends of the clamps just touch
the rim edge.
Then lock the turntable, selecting as the
locking point the area that is as inward
as possible depending on the form of
the rim.
70 - E - Operator's manual
nGlISH