Appendix 1; Appendix 2 - Agilent Technologies TPS-mobile 969-8400 Notice De Mode D'emploi

APPENDIX 1

The following three pages gathered in the "Appendix 1" are intended as a Quick Reference Manual of the
product, they contain the basic information needed to start operating with TPS-mobile.
These pages are intended as a separate document and, if needed, can be printed separately and attached
in paper format to the TPS-mobile for a quick reference work in the field.
The "Appendix 1" is applicable to following models:
969-8400
969-8402
969-8404
969-8406
969-8412
969-8416
969-8418
Basic information about the system activation and system components management is reported here follow-
ing:
• After TPS-mobile unpacking, perform a brief visual analysis of the system to be sure that no sign of dam-
ages due to transportation is present (critical parts are: TMP flange, Forepump fastening brackets, sys-
tem front panel and the system wheels).
• Check the system voltage on the Varian label stuck on the system electronic units case.
• If the voltage provided by your electrical supplier is compatible with the system voltage, you can connect
the provided power cord to the IEC320 electrical socket on the rear side of the system (see picture). The
socket is provided with a retention spring to avoid accidental disconnection of power cord plug – use the
spring to fasten the power cord plug.
969-8401
969-8403
969-8405
969-8411
969-8413
969-8417
969-8419
CONNECTION TO MAIN
PN 969-8433 is already supplied with
an integrated power cord so you don't
need to perform this step.
A1-1/3
969-8420 969-8421
969-8422 969-8423
969-8424 969-8425
969-8426 969-8427
969-8428 969-8429
969-8430 969-8431
969-8432 969-8433
Part Number (PN)
Serial Number (SN)
Electrical Data
Retention
Spring
Power cord
plug
NOTE
APPENDIX 1
87-901-005-01(A)