Publicité
8.1.3.
Wireless network/Wi-Fi specifications to connect to the controller
Wireless network / Wi-Fi | Specifications
Supported frequency
Supported standards
Supported security protocols
Bit rate
Integrated single antenna
Unsupported security protocols
Points to note when accessing the wireless
network/Wi-Fi:
8.1.4.
Establishing a connection via a wireless network router using the WPS function
The following description explains how to connect the kiln controller to a wireless network (Wi-Fi). This connection is
required so that they can see the data of your controller with the smartphone, tablet or computer in the ROHDE myKiln
app.
Establishing a connection:
Step
Description
1
Switch off the control unit.
d
2
Press the
key and switch on the control system.
3
Press and hold the
Press and hold the
4
main display.
d
5
Release the
6
Press the WPS button on the wireless router.
After a few seconds,
7
display, and it returns to normal.
The control system is now permanently connected to
8
the wireless network (Wi-Fi).
d
key when switching on.
d
"
"
key until
PAIR
appears on the
key.
"
"
PAIR
disappears from the main
71 / 384 - EN -
2.4 GHz
802.11b / 802.11g / 802.11n (at 2.4 GHz)
WEP / WPA / WPA2
Up to 150 Mbps (at 802.11n and 2.4 GHz)
Yes
OpenWiFi / WPA2 Enterprise
Unable to establish connections when:
−
an "acceptance page" (confirmation of
connection/terms of use) must be clicked after
establishing the connection,
−
or a username and password are required to
establish the connection.
Remark
If your router does not have a WPS button,
please proceed to the following section.
The control system is now ready to connect
to a wireless network (Wi-Fi).
Information on the WPS key on the wireless
router can be found in the router's instruction
manual and generally on the Internet.
If this procedure is unsuccessful, repeat the
steps starting at step 1 or try to connect as
described in the following section.
Publicité
