Publicité
5.1.4.
Setting the date & time
General information
• A battery-backed real-time clock for the date and time display is installed in the controller.
• It compensates for leap years.
• The changeover from summer to winter time must be performed manually.
• The internal battery has a service life of approximately 10 years.
Setting the date & time
Step
Display
Setting the date
1
2
3
4
5
22.01
6
23.02
7
23.02
8
01
9
01
10
Set time
07.45
11
12
Description
Switch off the control unit.
h
Press the
key and switch on the
control system.
h
Press and hold the
key when
switching on.
h
Press and hold the
key for about 3
seconds after switching on until the date
appears. The date is shown on the main
display starting with the year.
After the call-up, the numerical value for
the year flashes first.
h
g
Use the
or
key to select the
flashing number.
d
f
Use the
and
keys to change the
flashing number.
Change from year to month and from
g
month to day using the
The last numerical value for the day of the
current date appears alone on the main
display after switching on.
You can now either use the
advance to the time setting or wait about
15 seconds. The control system display
will then go dark for 2–3 seconds, and
the control system will restart
automatically. After the restart, the control
system is ready for normal operation
again.
g
Press the
key in the flashing day
display to go to the time.
After the call-up, the numerical value for
the hour flashes first.
55 / 384 - EN -
Remark
You must not perform any firing process
while setting the time and date.
The date is displayed in "YY.MM.DD"
format (year.month.day), with only
"YY.MM" appearing together on the
main display. By advancing with the
key, "DD" appears alone on the main
display.
key.
g
key to
The date is automatically saved with the
last setting after the restart.
For technical reasons, there is a point
between the hours and minutes in the
display and not a colon, as is usually the
case with times.
g
Publicité
