Publicité
5.5.3.
Additional functions
Function
Program delay "t
"
0
Program advance function
Y
Program pause facility
Z
5.6.
Cooling/end of the firing process
After firing, the kiln is switched off below 150°C and starts to cool down on its own.
Display screens:
Condition
Display 1
100 HOt
Above 40°C
Below 40°C
Description
You can use the program delay "t
with a time delay (at a specific time). Please refer to Section 6.1.3.
Press and hold the
function during firing. The controller will emit a short beep and immediately
advances the program by one step. Please refer to Section 6.1.4.
Activate the program pause function by pressing and holding the
seconds). The controller sounds a short beep, the current program is paused,
and the current kiln temperature is maintained. Please refer to Section 6.1.5.
Display 2
39 COOL
" or program delay to start the firing program
0
Y
key for 3 seconds to switch to the program advance
Program section
64 / 384 - EN -
Z
key (for 3
Description
⇒
As long as the kiln
temperature is above 40 °C,
the display alternates
between display 1 and 2
every 5 seconds.
⇒
Alternatively, you can end the
firing by pressing the
⇒ As soon as the kiln has
cooled below 40 °C, the
display alternates between
displays 1 and 2 every 5
seconds.
j
⇒ By pressing the
key, you
can now put the controller
into an idle state. The
controller is now ready for a
new firing (or the device can
be switched off).
j
key.
Publicité
