Publicité
6.1.4.
Program advance function
• Press and hold the
• The controller will emit a short beep and immediately advances the program by one step.
•
The effect of this is as follows:
If ramping, the controller switches to the next ramp phase, to the soak phase or ends the firing at the
current kiln temperature.
If soaking, then the controller will advance to the cooling phase, or else it will end the firing.
• These program changes only affect the firing in progress and are not saved.
6.1.5.
Program pause function
General safety information:
WARNING
Risk of serious damage to property due to too long a soak time when using the
program pause function.
⇒ If left too long at high temperatures, kiln damage could result.
⇒ The program pause function causes the program to pause, but the temperature is still
⇒ Leaving the ware too long at high temperatures could damage it or have a negative
Operation:
Step
Operation
Activating the program
pause facility
Ending the program pause
facility
Display screen
PAUSEd
6.2.
Operating notes
6.2.1.
Adjusting the firing values during firing
During the program, you can use the controller to change certain firing values:
g
• You can use the
• The firing value is shown on the main display, and you can adjust the value, as usual, using the
keys
• You can only change the values of the program steps being executed or that are still to be executed. Firing
will still carry on as normal while these changes are being made.
• The controller will return to its normal running display 20 seconds after key presses cease (or immediately
after END is displayed).
• Changes made to programs in this way are stored and are used for subsequent firings.
Y
Y
key for 3 seconds to switch to the program advance function during firing.
Z
maintained!
impact on the firing results.
Description
Activate the program pause function
by pressing and holding the
(for 3 seconds).
Exit the program pause function by
pressing and holding the
3 seconds).
If the program pause function is
active, the kiln temperature and a
PAUSEd
scrolling display "
alternately on the display every 5
seconds. The controller emits a short
beep twice during this time.
key to select the desired parameter during the firing process.
Remark
The controller sounds a short beep, the
Z
current program is paused, and the
key
current kiln temperature is maintained.
The controller emits a short beep, and
Z
key (for
the paused firing program continues.
• Program execution is suspended,
" appear
• The pause will come to an end
• The function is set to 2 h at the
66 / 384 - EN -
and the kiln will be held at its current
temperature.
automatically after a preset period.
factory.
d
f
and
Publicité
