Publicité
No.
Display
Indicator
FULL
12
55
13
20
14
d
f
*Press and hold the
or
Note:
• The controller automatically saves all variable values of the firing curve.
• If you do not press any keys within 20 seconds, the controller automatically reverts to the idle display. All
changes are automatically applied and saved immediately.
• Alternatively, you can exit the programming mode with the
However, changes made are automatically saved.
Meaning
Enter cooling rate Rmp
Enter cooling
temperature Tmp
Exit program memory
key while entering to quickly toggle between the displayed values.
62 / 384 - EN -
Description
d
•
Press the
and
cooling rate.
•
The cooling rate appears on the main
"
1
display as:
–
(uncontrolled cooling rate) or
3
(program end).
•
If you do not enter
rate, the heating elements are switched off,
and the kiln starts to cool down naturally.
•
If you do not enter
the cooling rate, the temperature control in
the controller will be terminated at 150 °C,
and the main display will then show the
end of the firing. Alternatively, you can end
the firing by pressing the
g
•
Press the
key to select the next
program step.
3
d
• Press the
and
temperature.
•
Tmp
must be lower than Tmp
3
g
•
Press the
key to complete the program
input.
The program memory is exited, and the
controller returns to the default display on the
main display.
j
key and start the firing process immediately.
f
keys to select the
999
FULL
(°C/h),
END
FULL
in the cooling
END
(program end) in
j
key.
f
keys to select the
.
2
Publicité
