Publicité
Notes
"sees" appears instead of the total
playing time during programming or
during play, this means
eyou have programmed a track number
which exceeds 20, or
ethe total programmed time has
exceeded
100 minutes.
4 Repeat steps 2 and 3 to program the
remaining tracks you want to be played
in the order you want them to play.
S Press Da.
All the tracks play in the order you
chose.
To program
using the remote
command:
er
Set the CD/MD switch to CD.
Press
CD C>.
If the player starts playing, press gto
stop.
Press PROGRAM.
Press the numeric buttons in the order
you want them to play.
Press
CD E> again.
Playing starts.
a —
W 0
to
Press
Check
the program
Program a pause
ev"
Stop play
O(@)
Cancel
the program
CONTINUE'*
play
Erase a track from the CLEAR
end
Erase a specific
track © CHECK repeatedly so
the number
of the
track lights
up, and
—
—
es
CLEAR
Erase the entire
Clone
in stop mode
program
and twice while
playing
° After the last track appears, "END"
appears
in the display.
«+ "P" appears and the total playing time is
reset
to 0.00.
ose The program
is erased.
To change
the order of
tracks
Erase the entire program and create a new
1 Press TIME once to see the remaining
time of the track being played.
2 Press TIME again to see the remaining
play time of the whole program.
If you have inserted
a pause, the display
shows the remaining
time until the
pause,
3 Press TIME once more to retum to the
initial disolav.
Piaying Tracks
Repeatedly (repeat
play)
You can choose between two different
tepeat play modes. One repeats all the
tracks
in the current play mode;
the other
repeats a single track.
Repeating all the tracks (in any
play mode)
Press REPEAT once while playing so that
"REPEAT" appears in the display.
Repeating
a single track (in norma!
play onty)
Press REPEAT twice while playing the
desired track so that "REPEAT 1" appears
in the display.
+
1.57
To cancel repeat play
Press REPEAT so that "REPEAT" or
"REPEAT I" disappears from the display.
Publicité
