Publicité
———
—
—
—
Inserting the
Batteries
Install two size AA (RO) batteries in the
supplied remote commander for remote
control.
1 Slide the lid to remove it.
2 insert two size AA (Ré) batteries.
Match the + and - to the diagram in
the battery compartment.
3 Slide the lid to replace it.
Battery life
You can expect the remote commander to
operate for about six months {using Sony
SUM-3 (NS) batteries) before the batteries
run down. When the batteries no longer
operate the commander, replace all the
batteries with new ones,
To avoid battery leakage
if you are not going to use the commander
for a long time, remove the batteries to
avoid damage caused by corrosion from
battery leakage.
Setting the Clock
The built-in clock shows the time in the
display even if the power is off. You need
to set the clock to enjoy the tumer-activated
features of your stereo system.
Use the buttons on the unit to do this
operation.
CONTROLLER indicator
2,4
3.5
ENTER/NEXT indicator
1 Press CLOCK SET
The CONTROLLER indicator
ENTER/NEXT indicator and the hour
indication
begin flashing.
=U +00AM
2 Set the cwrent hour by tuming
CONTROLLER ( + /-) until the correct
hour appears.
To set the clock
Turn CONTROLLER
ahead
the
+ side
the
- side
& Set the current minute by tumung
CONTROLLER ( +/-) until the correct
minute appears.
a
ae
S Press ENTER/NEXT.
The clock starts running and the upper
dot flashes.
Use the time signal to set the clock
accurately.
To check the time while power Is
on
Press DISPLAY as many times as required
The current
time appears
To correct the clock setting
Repeat
steps 1 to S.
Publicité
