Publicité
Care and Cleaning
1 .
The EZLock Pressure Cooker is made of high-quality, heavy gauge, stainless
steel .
2 .
The pressure cooker pot is dishwasher safe but the lid is not . The lid
should be washed by hand with warm water, mild dishwashing soap and
a nonabrasive cleaning pad . Do not use metal scouring pads or abrasive
cleaners as they will scratch the pot and possibly ruin the finish .
3 .
To remove stubborn stains and any discoloration in the interior of the
pressure cooker, try adding the juice of half a lemon and 1 to 2 cups of water
to the pressure cooker pot . Cook at high pressure for 15 minutes, and then
remove from heat . Let pressure release naturally, and then wash as usual .
4 .
After cleaning, towel dry with a clean, soft kitchen cloth .
5 .
In order to extend the life of the silicone gasket, remove after each use and
wash with warm water and mild, dish washing soap . Rinse and dry well,
then cover with a thin coat of vegetable oil before replacing . For increased
safety and best results, the silicone gasket should be replaced approximately
every 12-18 months, depending on the usage . You can order a new gasket
by calling ZAVOR Customer Service Number to receive an order form at:
1-855-928-6748, or by going to the online shop section of our website: www .
zavoramerica .com .
6 .
To store, DO NOT LOCK THE LID IN PLACE . Simply place the lid upside
down on top of the pressure cooker pot . This will avoid the risk of a vacuum
forming inside the cooker during storage, which would make the opening of
the lid difficult . It will also prevent stale odors from forming inside the cooker .
7 .
Before using the ZAVOR EZLock Pressure Cooker, always check the
handles, to make sure that they are securely screwed in place . If not, tighten
the handle screws with a screwdriver .
8 .
Replacement Parts: Only use authentic replacement parts manufactured and
distributed by ZAVOR America, Inc . The use of any unauthorized parts and
or attachments may cause unit failure and will void any warranty protection
provided by the manufacturer . You can order spare parts by calling ZAVOR
Customer Service Number at: 1-855-928-6748, or by going to the online
shop section of our website: www .zavoramerica .com .
16
Cleaning the Pressure Valve
After every use, check to make sure that the Pressure Valve is clear of any built-
up particles . To do so, move the pressure valve to the steam position and remove
the valve (see detailed instructions below) . Clean it by running water through it .
Next, lift the lid up to the light and look through the hole under the pressure valve .
Make sure you can see through it and there are no food particles blocking it . If
necessary, clean it with a small brush or pipe cleaner .
1 .
TO REMOVE THE PRESSURE VALVE FOR CLEANING PURPOSES:
Move the operating valve to the pressure release position . Jiggle the
pressure valve side to side as you pull it gently upwards to remove it from its
socket .
2 .
TO REPLACE THE VALVE AFTER CLEANING: Hold the pressure valve over
the vent pipe and push the pressure valve down until it is seated properly
into position .
17
Publicité
