Publicité
(88)
Haojue DL160 99011H41110H000 V01 2023-8-26 08:25
switch is turned from position "%" to "*": engine rpm
7 will be alight once, all displayable content
indicator
on the LCD will start scan. After that, the dashboard
restore usual display.
BCAUTION
Do not spray the dashboard with high-pressure
water directly.
BCAUTION
Never wipe the dashboard with any cloth that
has been in contact with gasoline, kerosene,
alcohol, brake fluids or other organic solvents, or
else the dashboard will suffer partial cracking or
discoloration as a result.
BCAUTION
EN
If the content displayed on the LCD is incomplete or
the indicators will be not alight during the self-test,
it suggests that the dashboard has fault.
BCAUTION
Do not frequent self-test in short time, otherwise
the dashboard may be damaged.
LEFT TURN SIGNAL INDICATOR 1 =
When the turn signal switch is pushed to left, the left turn
signal indicator will flicker accordingly.
(88)
Haojue DL160 99011H41110H000 V01 2023-8-26 08:25
NOTE: If the turn signal fails to work due to a broken
lamp, internal circuit failure or faulty wire connection,
the indicator on the dashboard will remain light up
continuously or flicker at a high frequency.
ABS INDICATOR 2
This indicator normally comes on when the ignition switch
is turned "*" and goes off after the motorcycle speed
exceeds 5 km/h.
If there is a problem with the ABS (Anti-lock Brake
System), this indicator comes on. The ABS does not
operate when the ABS indicator is on.
NOTE: If the ABS indicator goes off after you start the
motorcycle but before you begin riding, check the ABS
indicator function by turning off and on the ignition switch.
When the motorcycle speed reaches a certain set value,
the ABS indicator turns off. If the ABS indicator does not
come on when the ignition switch is turned on, you should
have the system checked by an authorized Haojue dealer
as soon as possible.
NOTE: If there is a different speed between the front wheel
and the rear wheel, the ABS indicator may possibly come
on. In such a case, check if the ABS indicator comes on
by turning off and on the ignition switch. After that, check
if the ABS indicator goes out after the motorcycle speed
exceeds 5 km/h. If the ABS indicator does not go out, you
should have the system checked by an authorized Haojue
dealer as soon as possible.
14
Publicité
