Publicité
NOTE: Only when the key hole is in the two positions in
the figure above can the key be completely inserted, pulled
out and turned and the ignition switch could be made on,
off and locked. If the key is partially inserted into the key
hole, the key can be turned to any positions; however, the
key cannot be completely inserted into the ignition switch
and no function can be realized.
SADDLE LOCK SWITCH
When dismantling the saddle, insert the key into the lock
hole and turn it clockwise to make the saddle bounce off.
When installing the saddle, insert its front and then press
its rear until a crack is heard that suggests that the saddle
has been locked.
Haojue DL160 99011H41110H000 V01 2023-8-26 08:25
Failure to install the saddle properly could allow
the saddle to move and cause loss of rider control.
Latch the saddle securely in its proper position.
HELMET HOOK
There are helmet hooks under the
saddle. To use them, remove the
saddle, hook your helmet fastener
ring to the hook and refit the saddle.
Riding with a helmet fastened to either helmet hook
can interfere with rider control.
Never carry a helmet fastened to a helmet holder.
Fix the helmet securely atop the saddle if you must
carry it.
DASHBOARD
Starting self-test will be carried out when the ignition
13
Haojue DL160 99011H41110H000 V01 2023-8-26 08:25
BWARNING
BWARNING
(87)
EN
(87)
Publicité
