Publicité
BWARNING
Riding the motorcycle with the ABS indicator lights
on can be hazardous.
If the ABS indicator blinks or comes on while
riding, stop the motorcycle in a safe place and turn
off the ignition switch. Turn the ignition switch "*"
after a while and check if the indicator comes on.
• If the indicator goes off after starting to ride, the
ABS will be functioning.
• If it does not go off after starting to ride, ABS is
not functioning, and the brakes provide normal
stopping ability. You should have the system
checked by an authorized Haojue dealer as
soon as possible.
HIGH BEAM INDICATOR 3 9
The high beam indicator will light up when the high beam
of the headlamp is turned on.
NEUTRAL GEAR INDICATOR 4 N
When the gear is in the neutral position, this indicator will
light up. If others, this indicator will be off.
MALFUNCTION INDICATOR 5 G
When the ignition switch is turned from "%" position to "*"
position, the malfunction indicator comes on, as soon as
the engine starts, the malfunction indicator should go out.
If the malfunction indicator comes on and remains lit, have
your authorized Haojue dealer check your motorcycle as
soon as possible.
Haojue DL160 99011H41110H000 V01 2023-8-26 08:25
RIGHT TURN SIGNAL INDICATOR 6 8
When the turn signal switch is pushed to right, the right
turn signal indicator will flicker accordingly.
NOTE: If the turn signal fails to work due to a broken
lamp, internal circuit failure or faulty wire connection,
the indicator on the dashboard will remain light up
continuously or flicker at a high frequency.
ENGINE RPM INDICATOR 7
The engine rpm indicator 7 will light or blink when the
engine speed reaches a preset engine rpm.
LIGHT/BLINK/NO LIGHT Mode Selection
1. To enter the selection mode, turn on the ignition
switch.
2. Press the SEL button 9, switch to the TOTAL
(odometer) state.
3. Press and hold the SEL button 9 for more than 2
seconds to enter the mode that the backlight of the
dashboard can be adjusted.
4. Press the ADJ button 8 to adjust the backligh, there
are 5 levels.
5. After selecting the backligh brightness level, press the
SEL button 9, enter the engine rpm indicator (LIGHT
/BLINK/NO LIGHT) mode.
6. Push the ADJ button 8 to change the lighting mode.
The mode changes as follows: LIGHT → BLINK →
NO LIGHT → LIGHT. The engine rpm indicator 7
comes on steady in the LIGHT mode and blinks in the
BLINK mode. The engine rpm indicator mark "?"
15
Haojue DL160 99011H41110H000 V01 2023-8-26 08:25
(89)
EN
(89)
Publicité
