Publicité
RIGHT HANDLE SWITCHES
Accelerate
ENGINE STOP SWITCH 1
The engine can only start up when the switch is placed at
the "*" position, and the ignition circuit is connected. If
the switch is at the "%" position, the ignition circuit is cut
off. This is an emergency stop switch.
ELECTRIC STARTUP BUTTON 2 #
This button is used for operating the starting motor. With
the ignition switch at the "*" position, the engine stop
switch at "*" and the transmission in neutral, grasp the
clutch lever and push the electric starter button # to
operate the starting motorcycle to start the engine.
Haojue DL160 99011H41110H000 V01 2023-8-26 08:25
Engaging the starter motor for more than five
seconds at a time can damage the start motor and
wiring harness from overheating.
Do not engage the starter motor for more than
five seconds at a time.
each two usage of electric startup button is about
ten seconds.
several attempts, check the fuel supply and ignition
system.
Refer to the "TROUBLESHOOTING"
section in this manual.
When cleaning the motorcycle, do not clean
its electric parts with the high-pressure water,
particularly the handle switch.
Do not start the motorcycle when the fuel or engine
oil is insufficient.
NOTE: When the throttle opening more than 3/10, the
motorcycle not start, therefore, should make throttle
opening less than 3/10 when start.
21
Haojue DL160 99011H41110H000 V01 2023-8-26 08:25
BCAUTION
The interval between
If the engine does not start after
BWARNING
BWARNING
(95)
EN
(95)
Publicité
