Télécharger Imprimer la page

Haojue DL160 2023 Manuel D'utilisation page 117

Publicité

2. Remove the oil collecting pipe 2 together with the
clamp 1.
3. Drain all the waste liquid in the oil collecting pipe 2.
4. Reinstall the oil collecting pipe 2 and fasten the clamp
1.
NOTE: Be true that reinstall the collecting pipe.
NOTE: When air is very humid, properly increase the
check frequency.
SPARK PLUG
Spark plug check
Measure the spark plug gap with a thickness gauge. The
standard spark plug gap is 0.8–0.9 mm. If the measured
spark plug gap is out of standard range, adjust or replace
it with a new one.
Whenever removing carbon deposits, be sure to observe
the operational color of the spark plug's porcelain tip.
This color tells you whether or not the standard spark
plug is suitable for your type usage. A normal operating
spark plug should be very light brown in color. If the
spark plug is very white or glazed in appearance, it works
under overheating conditions. This spark plug should be
Haojue DL160 99011H41110H000 V01 2023-8-26 08:25
replaced with a colder one.
Spark plug replacement guide
An improper spark plug may have an incorrect fit or
heat range for your engine. This may cause severe
engine damage.
Use one spark plug listed below or equivalent.
Consult your Haojue dealer or a qualified mechanic
if you are not sure which spark plug is correct for
your type of usage.
NGK
CPR7EA
0.8–0.9 mm
CPR8EA Standard.
CPR9EA
NOTE: This motorcycle uses a resistor-type spark plug
to avoid jamming electronic parts.
plug selection may cause electronic interference with
your motorcycle's ignition system, resulting in motorcycle
performance problems. Use only the recommended spark
plug.
43
Haojue DL160 99011H41110H000 V01 2023-8-26 08:25
BCAUTION
BCAUTION
Remarks
If the standard spark plug is apt to get wet,
replace with this plug.
If the standard spark plug is apt to overheat,
replace with this plug.
(117)
EN
Improper spark
(117)

Publicité

loading