Publicité
WARNING
Unsafe Operation Hazard
Failure to install the jack locking pin could result in death
or serious injury. Be sure the tongue jack is locked in the
operating position with the jack locking pin.
To lower the jack foot (raise the trailer tongue)
•
Turn the jack handle counterclockwise (E, Figure 7)
to lower the jack foot (F) and raise the trailer tongue.
To raise the jack foot (lower the trailer tongue)
•
Turn the jack handle clockwise (G, Figure 7) to raise
the jack foot (H) and lower the trailer tongue.
To retract the tongue jack
WARNING
Unsafe Operation Hazard
Failure to support the trailer tongue before retracting the
tongue jack could result in death or serious injury. Be sure
the trailer tongue is securely supported before retracting
the tongue jack.
1. Be sure the trailer is securely supported by the tow
vehicle or other approved means.
2. Fully raise the jack foot.
3. Fold the jack handle into the transport position (I,
Figure 7).
4. Remove the jack locking pin.
5. Rotate the tongue jack 90° into the transport position
(J, Figure 7). Install the jack locking pin.
7
A
I
F
D
B
C
B
E
G
Using the Trailer Coupler / Lunette
Eye
Trailer Coupler
To connect the trailer to the tow vehicle
1. Lift up and pull back on the locking latch (A, Figure 8)
of the trailer coupler.
2. Lower the trailer coupler onto the vehicle ball hitch.
Make sure that the hitch ball (B, Figure 8) is fully
engaged in the coupler socket (C, Figure 8).
3. Push the locking latch forward and down. (It is self-
locking.) Install a padlock through the latch hole (D,
Figure 8) for added security.
4. Make sure that the coupler is fully installed on the ball
hitch.
To disconnect the trailer from the tow vehicle
1. Remove the padlock (if installed) from the trailer
coupler latch (D, Figure 8).
2. Lift the trailer coupler (A, Figure 8) latch up and back.
8
D
C
B
Lunette Eye
To connect the trailer to the tow vehicle
1. Remove the locking pin (A, Figure 9, if equipped)
from the pintle hitch (B, Figure 9).
2. Pull up on the latch (C, Figure 9), to open the pintle
hitch.
3. Lower the lunette eye (D, Figure 9) into the pintle
hook (E, Figure 9).
4. Close the pintle hitch. Make sure that the latch locks
the pintle hitch in place.
5. Install the locking pin (if equipped).
A
en
11
English
Publicité
