Publicité
15
B
C
Ref
Description
A
20 Amp, 120 Volt Duplex GFCI NEMA 5-20R
B
30 Amp, 120 Volt 3-Pole, 3-Wire RV NEMA TT-30R
C
30 Amp, 120/240 Volt 4-Pole, 4-Wire Twist Lock NEMA L14-30R
Emergency Stop
Some units are equipped with an emergency stop that
will immediately shut the entire unit down in case of an
emergency.
To Engage:
•
Push the emergency stop (A, Figure 16).
To Disengage:
•
Pull the emergency stop.
Make sure that you address the issue that caused the
emergency before you operate the unit again.
Unnecessary or excessive use of the emergency stop
may damage engine. Do not use the emergency stop to
shut down the unit during normal operation. See To Shut
Down The Engine.
16
A
Shutting Down The Unit
1. Shut down the engine. See Operation - Operating
The Engine.
2. The unit is now ready for transport. See
Transporting.
Maintenance
A
Before performing any maintenance, read Safety.
Scheduled maintenance is necessary for safe and
effective operation of the unit. Under extreme conditions
(dusty conditions, extreme heat or cold, etc.), more
frequent maintenance may be required.
Unsafe Operation Hazard
Operating or transporting a machine with worn, damaged
or missing parts could result in death or serious injury.
Replace worn, damaged or missing parts promptly.
Do not operate or transport the machine until all worn,
damaged or missing parts have been replaced, and
proper operation of the machine has been verified.
General
Use the pre-operation checklist as a general maintenance
guideline. See Pre-Operation Checklist.
Engine
For engine service intervals and other recommendations
specific to this unit refer to Specifications. Refer to the
Engine Operator's Manual for all other scheduled engine
maintenance procedures.
Engine Oil Drain
The unit is equipped with a remote engine oil drain (A,
Figure 17), located on the right side of the trailer toward
the rear. To drain the engine oil:
1. Place an approved container beneath the oil drain.
2. Remove the oil drain plug.
3. Open the oil drain valve, located on the engine oil
4. Allow the engine oil to drain completely into the
5. Close the oil drain valve.
6. Replace the oil drain plug, tightening securely.
7. Change oil filter as needed. Refer to Specifications.
8. Add oil to the engine. Refer to Specifications.
NOTICE
Failure to add engine oil will result in engine damage.
WARNING
pan (B, Figure 17, inset).
approved container. Be sure to dispose of used
engine oil according to local, state, province and/or
federal rules.
en
15
English
Publicité
