Publicité
17
A
B
Engine Coolant Drain
NOTICE
Failure to use the required coolant type (as stated in
the Specifications section) in the radiator may result
in damage to the engine and radiator, thus voiding the
warranty.
NOTICE
The mixing of different coolant types in the radiator may
result in damage to the engine and radiator, thus voiding
the warranty.
The unit is equipped with an engine coolant drain valve
(A, Figure 18). To drain the engine coolant:
1. Attach a 3/8" ID hose to the coolant drain valve, and
route the hose to empty into an approved container.
2. Open the coolant drain valve.
3. Let the engine coolant drain fully into the approved
container. Dispose of used engine coolant according
to local, state, province and/or federal rules.
4. Close the coolant drain valve, and remove hose.
5. Open the coolant fill access door (B, Figure 18), and
add coolant to the radiator. Refer to Specifications.
NOTICE
Failure to add engine coolant will result in engine
damage.
16
18
Electrical System
Generator
Refer to the Generator Operator's Manual for all
scheduled generator maintenance procedures.
Trailer
Frame
1. Check the trailer coupler for proper operation, and for
corrosion or damage. Replace as needed.
2. Inspect the trailer frame and body panels for rust,
nicks and chips. Use the proper touch-up paint to
touch up nicks or scratches. Contact your dealer for
additional information.
3. Inspect the axle, springs and undercarriage for wear
and damage. Replace as needed.
4. Inspect the safety chains for wear and corrosion
damage. Replace as needed.
Grease Points
1. Use NGLI consistency #2 high-temperature anti-
friction bearing lubricating grease for all trailer
mechanical pivot points.
B
A
www.allmand.com
Publicité
