Publicité
To install the battery
WARNING
Explosion Hazard
Failure to install the black negative (-) battery cable(s)
last could cause sparks and/or an explosion resulting in
death or serious injury. Always install the black negative
(-) battery cable(s) last.
1. Carefully place the battery in the engine compartment
with the battery terminals toward the front of the unit.
2. Install the battery hold-down on top of the battery.
Tighten the hardware securely.
3. Connect the red positive (+) battery cable(s) to the
positive (+) battery terminal.
4. Connect the black negative (-) battery cable(s) to the
negative (-) battery terminal.
5. Replace the terminal covers over the battery
terminals.
6. Close and latch the engine compartment cover.
19
Cleaning
WARNING
Entanglement / Sever Hazard
Failure to shut down the engine before cleaning the unit
could result in death or serious injury. Always shut down
the engine before cleaning the unit.
18
A
C
B
WARNING
Burn Hazard
Shut down the engine and let components cool before
cleaning the unit. Failure to do so could result in serious
burns.
NOTICE
Use caution when using compressed air or water / steam
pressure washers. Do not pressure–clean electrical
components, as this may cause damage.
Keeping the trailer clean is important to ensure proper
operation. Dirt and dust buildup acts as an insulator and
may cause the engine, generator and light assemblies to
operate at excessively high temperatures.
Use the following as cleaning guidelines:
1. Clean the trailer to remove all dust, dirt or other
foreign material.
2. Clean all electrical wiring and components by hand
using non-corrosive cleaner.
3. Clean the inside of the engine compartment.
4. Clean any oil or liquid spills inside the engine
compartment.
5. Empty the fluid containment tray. See Fluid
Containment System (FCS).
Fluid Containment System (FCS)
The contains a fluid containment system designed to
catch fuel, oil or coolant spills.
To drain:
1. Position a suitable container beneath the fluid
containment drain (A, Figure 20).
2. Remove the fluid containment drain plug. After the
fluid has been drained, install the drain plug. Apply
a small amount of thread sealant onto the drain plug
threads before installing.
3. Dispose of the fluid in accordance with EPA or other
governmental guidelines.
20
A
www.allmand.com
Publicité
