Keysight RP7970 Serie Manuel D'utilisation page 152

4 Using the Regenerative Power System
Only pins 4 through 7 can be configured as "coupled" pins. The designated pins will function as both
an input and an output, with a negative transition on one pin providing the sequence signal to the
other pins. The polarity of the pins is not programmable; it is set to NEGative.
In this example, pin 6 is configured as the output On control. Pin 7 is configured as the output Off
control. The ground or Common pins are connected together.
Front Panel Menu Reference
Select System\IO\DigPort\Pins.
Select pin 6, then Function, then On Couple.
Select Pins., select pin7, then Function, then Off Couple.
Repeat these steps for units #2 and #3
Once configured and enabled, turning the output on or off on any coupled unit will cause all coupled
units to turn on or off according to their user-programmed delays.
152
SCPI Command
To set pin 6 of unit 1 as the ON control:
DIG:PIN6:FUNC ONC
To configure pin 7 of unit 1 as the OFF control:
DIG:PIN7:FUNC OFFC
Repeat commands for units 2 and 3.
Keysight RP7970 & RP7980 Series Operating and Service Guide