Ecolab LMI03 Manuel D'utilisation page 137

7.3.3 Alarms
Alarm delay for empty detergent
Available only in conductivity mode.
Sets the time after which the alarm is triggered.
Starting point: 'Options' screen (12)
1.
Select 'Settings'
2.
Select 'Alarm Settings '
3. Set the alarm delay in seconds using
4.
Confirm the settings with
ð Alarm delay for empty detergent is set.
Additional settings in the Alarm submenu
n Maximum proportioning time exceeded (61)
exceeded' on page 54
n Alarm delay for high detergent concentration (62)
concentration' on page 55
Ä Chapter 7.1 'Initial start-up' on page 43
(13) and confirm with
(60) and confirm with
,
.
Ä 'Maximum proportioning time
Ä 'Alarm delay for high detergent
53
Installation and start-up
.
.
and .
MAN049432 Rev. 03-03.2024