Publicité
Les langues disponibles
Les langues disponibles
7.3.2
Configure outputs
Controller settings for setpoints 1 and 2
Control of post-proportioning with proportioning time limit using relay outputs.
Controller settings
Starting point: 'Options' screen (12)
1.
Select 'Settings'
2.
Select 'Controller Settings for Setpoints 1 and 2' (50) and confirm with
3.
Set controller settings setpoints 1 and 2 using ,
4.
Confirm the settings with
ð Controller settings for setpoints 1 and 2 are set.
Additional settings in the Controller Settings for Setpoints 1 and 2 submenu
n
Pre-proportioning Delay Time and Proportioning Time (51)
time and proportioning time' on page 52
Ä Chapter 7.1 'Initial start-up' on page 43
(13) and confirm with
.
51
Installation and start-up
.
and
.
Ä 'Pre-proportioning delay
MAN049432 Rev. 03-03.2024
.
Publicité
