Publicité
Les langues disponibles
Les langues disponibles
7.3
Settings
7.3.1
Conductivity
Calibration of conductivity and temperature
The setting compares the measured conductivity value (actual value) with a preset value
(nominal value). If the actual value is less than the nominal value set for conductivity, a
metering pump starts up in order to increase the concentration of the solution.
Conductivity measuring cell
Starting point: 'Options' screen (12)
1.
Select 'Settings'
2.
Select 'Conductivity Measuring Cell'
3.
Set the calibration using ,
4.
Confirm the settings with
ð Calibration of conductivity and temperature is set.
Additional settings in the Conductivity Settings submenu
n
Calibration of conductivity and temperature compensation (41)
compensation' on page 50
Ä Chapter 7.1 'Initial start-up' on page 43
(13) and confirm with
(40) and confirm with
and
.
.
49
Installation and start-up
.
.
Ä 'Temperature
MAN049432 Rev. 03-03.2024
Publicité
