Sharp VZ-2000H Mode D'emploi page 6

a] OPERATION WITH AC POWER SUPPLY
AC INPUT socket
AC outlet
"Push the POWER switch to the "m ON" position, insert the AC connector
into the AC input socket located on the rear of the unit.
"When plugged into an AC outlet, the unit is ready to use,
Notes
to be used for an extended period of time.
4 | OPERATION WITH DC POWER SUPPLY (BATTERIES)
3ATTERY INSTALLATION
—————
Removing the battery Battery insertion
compartment cover
<
Fig. 2
@ Disconnect the AC supply lead from the unit.
DB Place the unit on a soft surface, such as a sofa or blanket, in order not
to damage the cabinet or dust cover, and remove the battery compart-
ment cover. (Fig. 1)
@ Insert ten new type HP-2 or UM/SUM-1 batteries (1.5 cell) into the
battery compartment as shown in Fig. 2,
*With the ribbon underneath the batteries. The ribbon will facilitate —
their later removal. Be sure to observe correct polarity for all
batteries.
@ Replace the battery compartment cover. The unit can now be operated
on its internal battery power supply.
(Notes
' «Remove the batteries when they become weak or whenever you
: expect that the unit will not be used for a long period of time. This
' will help prevent possible damage to the unit due to battery leakage.
_* If dust should accumulate between the batteries and battery termi-
nals, contact becames imperfect and may hinder the unit's operation.
This can be avoided by keeping the contact parts clean.
[é
12V DC
(Cigarette lighter socket)
DC 15V Socket
Car battery adaptor (not supplied)
BATTERY LEVEL CHECK
Push the "TAPE" input selector button,
Push the PLAY ( ® } button.
and hold in that position.
SOSe
BATT
_ oe es Cs) (—_
ESRD omaaw—
The battery level is adequate if three or more LED indicators light up,
ee BATT
Ll 7 @e Hoc Co
Leéver J[-J03)(8 (3 JLoI(3 Jelles
The battery level is inadequate if only 2 or less LED indicators tight
up.
Push the POWER switch to the "M STAND-BY" position, remove the old
batteries and replace them with new ones.
Note
When the batteries are low, even though you can hear the radio you
may not be able to play records or tapes. So replace the batteries as.
soon as possible.
When using this stereo system indoor, it is advisable to use an AC power
source.
OPERATION WITH EXTERNAL DC POWER SUPPLY (15 VOLTS)
You cannot play records on this unit inside a car. It has been designed to
operate within a range of DC 12 to 16 volts. When operating on a DC 12V
car battery with negative ground, use acar battery adaptor (not supplied).
When using a car battery as a power source, be sure to keep the unit out
of direct sunlight outside of the car and to place it on a level surface,
@ Connect the supply lead with plug of the adaptor to the external DC
input socket (DC 15).
@ Connect the other end of the lead into the cigarette lighter socket
of the car's instrument panel.
Note
Use of an external DC power source automatically cuts off the elec-
trical current from the internal batteries.