Selve Commeo/iveo SE Plus-RC Notice De Réglage page 58

iveo initial operation/setting by radio
6.1.3. Manual setup-mode, deletion and manual setting of the end positions
in operation bottom position, top position
When the movement is interrupted once, the system is in manual setup-mode.
In manual setup-mode, the lower end position must be set and stored first. Afterwards, the
upper end position can be set and stored.
Caution! Only connect the radio motor that you wish to program to the mains. It is not possi-
ble to program more than one motor at the same time.
Setting with trans-
mitter
6 s
or
3 s
or
3 s
1 s
Drive
Connect to power.
Press the UP and DOWN buttons at the transmitter at
the same time. The transmitter is temporarily pro-
grammed into the motor.
Press the STOP button of the transmitter for 6 seconds.
Move the motor to the lower end position with the UP
or DOWN button.
STOP
Press the STOP button of the transmitter for 3 seconds.
The correct rotation direction assignment will be car-
ried out at the end of the end position setting.
Move the motor to the designated upper end position.
STOP
Press the STOP button of the transmitter for 3 seconds.
The end positions are now set and the rotation direc-
tion assignment is correct. Perform a test run.
Press the PROG button at the transmitter. The transmit-
ter is now permanently programmed.
58