Selve Commeo/iveo SE Plus-RC Notice De Réglage page 46

Setting of the end positions
4.5.2. Manual setup-mode, deletion and manual setting of the end positions
in operation bottom position, top stop/release
When the movement is interrupted once, the system is in manual setup-mode.
Important: A limit stop for the upper end limit is necessary!
First the lower end limit has to be run-up to. From there move against the upper limit stop
without interruption.
Setting with Drive
setting switch
E
6 s
E
E
3 s
E
Press the E button of the setting switch for 6 seconds. The
motor will switch to manual setting mode. Both limit positions
already set will be deleted.
Move the motor to the lower end position with the UP or
DOWN button.
STOP
Press the E button for 3 seconds.
The correct rotation direction assignment will be carried out at
the end of the end position setting.
Run against the limit stop at the top without stopping; the
motor stops automatically. The correct direction of rotation
STOP
assignment has been made.
Perform a test run: The motor moves up against the limit stop
and relieves shortly.
46