Selve Commeo/iveo SE Plus-RC Notice De Réglage page 53

commeo initial operation/setting by radio
Note for settings under point 5.2.: The motor must be selected for this setting with a trans-
mitter in SELECT mode (Status LED flashes slowly in orange). After completing the setting,
the motor is still selected (see point 5.).
5.2.3. Manual setup-mode, deletion and manual setting of the end positions
in operation bottom position, top position
When the movement is interrupted once, the system is in manual setup-mode.
In manual setup-mode, the lower end position must be set and stored first. Afterwards, the
upper end position can be set and stored. Drive against the top stop until the motor is auto-
matically switched off.
Operation
6 s
or
3 s
or
3 s
Drive
Press the STOP button of the transmitter for 6 seconds.
The motor will switch to manual setting mode. Both
limit positions already set will be deleted.
Move the motor to the lower end position with the UP
or DOWN button.
STOP
Press the STOP button of the transmitter for 3 seconds.
The correct rotation direction assignment will be car-
ried out at the end of the end position setting.
Move the motor to the designated upper end position.
STOP
Press the STOP button of the transmitter for 3 seconds.
The end positions are now set and the rotation direc-
tion assignment is correct. Perform a test run.
Note: The transmitter may not yet have been pro-
grammed. See point 5.2.4. to program a transmitter.
53
EN